SiZING GUIDE

---

Our collars are adjustable & have holes for the buckle every 0.50" apart. If you have a different preference, please note this in the comment section of your order. 

If your dog is between sizes, we will adjust the collar holes accordingly. If this is an issue, let us know in the order comments. If you require a special size not listed please don't hesitate to reach out & ask. 

Our collars currently come in the following sizes:

• XS – 10-13” in 5/8” & 3/4" width
• S – 12-16” in  3/4" & 1" width
• M – 15-19” in 3/4" & 1" width
• L – 18-22” in 1” & 3/4" width
• XL – 21-25” in 1” width or wider 

1. Place a flexible measuring tape snugly around your dog’s neck where the collar usually sits. Loosen the tape a little to add the appropriate amount of breathing room. 

2. Read the measurement off the tape.

3. If measuring for a harness, please use the same techniques for measuring a collar, however, measure the girth & the base of the neck circumference. 

Lay the collar flat on a surface in its open position. 

 Measure from the female end of the clip to the base of the male end / the end of the fabric. Do not measure from the start of the male clip, this will cause a measurement error resulting in the collar being too big. 

For buckle  collars measure from the start of the material to the currently used hole. Do not measure from the start of the buckle to the currently used hole, this will cause a measurement error resulting in the collar being too big.